Honeywell Temperature & Humidity Sensor with LCD TABLE OF CONTENTS INTRODUCTION 3 PRODUCT OVERVIEW 4 BEFORE YOU BEGIN 5 BATTERY INSTALLATION 7 LOW BATTERY WARNING 7 PLACEMENT OF THE REMOTE SENSOR 7 GETTING STARTED 8 TRANSMISSION COLLISION 9 PRECAUTIONS 9 SPECIFICATIONS 10 FCC STATEMENT 11 DECLARATION OF CONFORMITY 12 STANDARD WARRANTY INFORMATION 13 (TS33C) USER MANUAL 2
INTRODUCTION PRODUCT OVERVIEW Thank you for selecting the Honeywell Temperature and Humidity Sensor with LCD. This device register, display and transmits temperature and humidity from the remote location to the designated FEATURES • Remote temperature and humidity transmission to the main unit via 433 MHz signal main unit (receiver).
to the remote sensor. B. BATTERY COMPARTMENT • Holds two AA-size batteries C. RESET • Resets all readings D. CHANNEL SWITCH • After reception is established (the remote temperature and humidity will appear on the main unit’s display), position the remote sensor and the main unit within the effective transmission range of 100 feet (30 meters). • Selects the desired channel E. WALL-MOUNT RECESSED HOLE • Keeps the remote sensor on the wall F.
BATTERY INSTALLATION GETTING STARTED NOTE: Install the batteries; select the channel and temperature in C° or F° before mounting the remote sensor. After batteries are installed; remote sensor will transmit temperature and humidity readings at 45 second intervals. The main unit may take up to two minutes to receive the initial readings. • Remove the screws from the battery compartment with a small Phillips screwdriver. • Set the channel. The switch is located in the battery compartment.
• • Remove the batteries from the main unit and reinstall them in the same manner. The remote temperature and humidity appeared on the main unit’s display will show that transmission is being received successfully. TRANSMISSION COLLISION Signals from the other household devices such as wireless doorbells, home security systems, and entry control, may interfere with this product or cause temporary reception interruption. This is normal and will not affect the general performance of the product.
FCC STATEMENT DECLARATION OF CONFORMITY This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference We Name: Hideki Electronics, Inc. Address: 7865 SW Mohawk, Tualatin, OR 97062 received, including interference that may cause undesired operation.
STANDARD WARRANTY INFORMATION This product is warranted from manufacturing defects for one year from date of retail purchase. It does not cover damages or wear resulting from accident, misuse, abuse, commercial use, or unauthorized adjustment and repair. Note that online product registration is required to ensure valid warranty protection. To register your product, go to our Company website at: www.honeywellweatherstations.com. Click Online Product Registration under the Customer Service menu.
