Operator's Manual

5 69-1353
Battery Installation
The Telephone Access Module requires a 9-volt alkaline
batter
y
(not included) to provide the power to dial an
alert indicatin
g
an extended power interruption. (See
Power Outa
g
e Settin
g
discussion in Confi
g
urin
g
Your
Telephone Access Module section.)
CAUTION
Dead or Missing Battery Hazard.
Can prevent Telephone Access Module from
dialing power outage alert.
Check batter
y
annuall
y
or before leavin
g
for
extended absence.
To install or replace the batter
y
:
1.
Remove the front cover latch pin (Fi
g
. 2).
2.
Grasp the top of the front cover and swin
g
it down
(Fi
g
. 3).
3.
Connect the batter
y
leads to the batter
y
(Fi
g
. 4).
4.
Insert the batter
y
in the slot.
5.
Close the cover.
6.
Re-insert the front cover latch pin.
Fig. 2. Removing front cover latch pin.
M14813
on line
momentary flash - ok
steady flash - replace
on continuously - replace
auxiliary input
battery