Operator's Manual

15 69-1353
Entering Your Identification (ID) Number
Use
y
our home telephone number as
y
our ID number.
The ID is announced when a dial-out alert messa
g
e is
sent.
After
y
ou enter Confi
g
uration Number 1, if
y
our ID is not
y
et pro
g
rammed,
y
ou hear, “The ID is not pro
g
rammed.”
If
y
our ID is pro
g
rammed, and is correct, press the * ke
y
to return to the Confi
g
uration Menu.
You will hear, “To chan
g
e the ID number, press 1.”“Enter
the ID followed b
y
the # ke
y
.”
1.
Enter an ID number with less than 25 di
g
its, fol-
lowed b
y
the # ke
y
. You will hear, “Your ID is
(
y
our ID number).”
2.
If this is the ID
y
ou want pro
g
rammed, press the *
ke
y
to return to the Confi
g
uration Menu.
If the ID is not entered correctl
y
,
y
ou will hear, “Invalid
ID.” Follow the menu and these instructions and enter a
new ID.
Low Limit Setting
The Low Limit settin
g
is used to activate an alert when
the displa
y
ed temperature on the thermostat is lower
than the value
y
ou set. The settin
g
ran
g
e for the Low
Limit Settin
g
is 40
o
F (4°C) to 65
o
F (18°C) in 1
o
F (1°C)
increments. The factor
y
default settin
g
is 50
o
F (10°C).
If the thermostat displa
y
s a temperature lower than
y
our
low limit settin
g
and
y
our dial-out alert is active, the
Telephone Access Module dials out. When
y
ou answer
the phone,
y
ou will hear, ”Hello, this is a Hone
y
well alert
messa
g
e from (
y
our ID here). A Low Limit Alert was
observed.”
CAUTION
Property Loss Hazard.
Do not assume your designate received and
acted on the active alert.
Prepare to act promptl
y
; time ma
y
be critical.
CAUTION
Property Loss Hazard.
Do not rely only on the Telephone Access
Module to identify potential problems in
your home (like detecting low room
temperatures that can freeze water pipes).
Have someone periodicall
y
check
y
our home
while
y
ou are awa
y
.
Set the Low Limit settin
g
a few
de
g
rees below the settin
g
on
y
our
thermostat. This wa
y
y
ou can be
notified if the temperature drops
below
y
our thermostat settin
g
.
This provides an earl
y
notice.
After enterin
g
Confi
g
uration Number 2, if
y
our Low Limit
Settin
g
is set to the factor
y
settin
g
,
y
ou will hear, ”The
Low Limit Settin
g
is 50°F (°10C).”
If
y
our Low Limit settin
g
is correct, and the value
y
ou
want, press the * ke
y
to return to the Confi
g
uration
Menu.
You will hear, “To chan
g
e the Low Limit Settin
g
, press
1.” “Enter the Low Limit Settin
g
followed b
y
the # ke
y
.”
80
90
70
60
90
80
70
60