Users Manual Chapter 5

Thor VM3A Vehicle-Mounted Computer 113
To use the strain relief clamp(s):
1. Determine the proper strain relief cable clamp. There are three sizes of cable
clamps on the Standard Dock which should be matched to the cable to be
secured. For example, the largest clamp (on the left when viewing the back of
the dock) is designed to secure the power cable. For the Enhanced Dock there is
a single cable clamp. Use this clamp for the power cable, Use the brackets for
all other cables.
2. Remove the strain relief clamp from the computer by turning the screw
counterclockwise. Put the screw aside in a safe location.
3. Slide the strain relief clamp over the cable.
4. Using a Phillips screwdriver and the screw that was removed, refasten the
clamp holding the cable to the dock. Do not stretch the cable. Leave enough
slack in the cable to allow it to be connected and disconnected easily when
needed.
5. Continue in this manner until all cables are secured to the dock.
To use the strain relief brackets (Enhanced Dock only):
1. Secure the cable to the bracket with plastic tie straps (cable ties).
2. If necessary, the cable ties can be trimmed to length after installation. Cut the
excess tie length off flush and not at an angle to prevent sharp edges that may
cause cuts.