Users Manual Chapter 5

112 Thor VM3A Vehicle-Mounted Computer
The headset consists of an earpiece, a microphone, a clothing clip, and a cable.
1. Do not twist the microphone boom when adjusting the microphone. The micro-
phone should be adjusted to be about two finger widths from your mouth.
2. Make sure the microphone is pointed at your mouth. Note the small “Talk” label
near the mouthpiece. Make sure the Talk label is in front of your mouth. The
microphone cable can be routed over or under clothing.
3. Follow the safety guidelines below when wearing the headset.
Under Clothing
• Leave the cable exposed only at the top of the collar.
• Be sure to leave a small loop of cable to allow movement of your head.
Over Clothing
• Use clothing clips to hold the cable close to your body.
• Tuck the cable under the belt, but leave a small loop where it goes under the belt.
• Do not wear the cable on the front of your body. It may get in your way or get
caught on protruding objects.
Strain Relief Cable Clamps
Equipment Required: Phillips screwdriver (not supplied by Honeywell)
There are five strain relief cable clamps secured to the Standard Dock.
There is one strain relief cable clamp and three strain relief brackets for securing
cables to the Enhanced Dock.
Use the strain relief clamps to secure audio, power, and I/O cables attached to the
dock.
Use the left-most strain relief clamp for the power cable.
Standard Dock
Enhanced Dock