User Guide

TStatSpec

GETTING CONNECTED TO THE DEVICE

Connecting to the device

This section describes the procedure of connecting to the

USB-TIM adapter. When you launch TStatSpec™, it

automatically detects the USB-TIM adapters connected to the

PC and establishes the connection to the first USB-TIM it

comes across.

If TStatSpec™ is already launched and then you connect the

USB-TIM adapter, press F2 or click on the ‘Connect to USB-

TIM’ icon in the toolbar to connect to the USB-TIM

adapter.You can also select ‘Connect’ option from USB-TIM

menu.

Click on the ‘Disconnect from USB-TIM’ icon in the toolbar or

press Ctrl+F2 to close connection between TStatSpec™ and

the USB-TIM.

Icons:

If the USB-TIM adapter is disconnected from the PC at any

point (after TStatSpec™ is established connection to USB-

TIM), the following warning message is displayed and any

subsequent online operations will fail. Re-connect the USB-

TIM adapter and press F2 or click on the ‘Connect to USB-

TIM’ icon in the toolbar.

NOTE:

1. Connection status indicates connection to USB-

TIM only, it does not indicate if T7350 is actually

connected.

2. Connect and Disconnect options are available

only if a Configuration is opened in the TStat-

Spec™.

3. When other USB devices other than USB-TIM are

connected to the PC, TStatSpec might not be able

to detect USB-TIM and hence cannot communi-

cate to T7350. Workaround: If TStatSpec is

unable to connect to the USB-TIM inspite of

proper connections, remove other Prolific devices

and connect only the USB-TIM device.

Indicates that the USB-TIM adapter is

disconnected. Click this button to

establish the connection between

USB-TIM adapter and TStatSpec™

tool.

Indicates that the USB-TIM adapter is

connected. Click this button to close

the connection between USB-TIM

adapter and TStatSpec™ tool.