Installation Information

INSTALLATION INSTRUCTIONS
69-1382-4
® U.S. Registered Trademark
Copyright © 2003 Honeywell International Inc.
All Rights Reserved
UC100A Ultraviolet
Air Treatment System
Replacement Lamp
APPLICATION
The UC100A Ultraviolet Air Treatment System Replacement
Lamp is for use with the UV100A Ultraviolet Air Treatment
System. There are four different replacement lamps for the
five models of Ultraviolet Air Treatment Systems. See Table 1
for your model.
INSTALLATION
When Installing this Product…
1. Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous condi-
tion.
2. Check the rating given in the instructions and on the
product to make sure the product is suitable for your
application.
3. Removal and replacement of the ultraviolet lamps can
easily be done by the homeowner following these
instructions. The homeowner can also call an experi-
enced service technician.
4. After installation is complete, check out product opera-
tion as provided in these instructions.
Replacing Your Lamps (Annually)
CAUTION
Personal Injury Hazard.
Power supply can cause electrical shock.
Disconnect power supply before replacing ultraviolet
lamp(s).
Do not open base unit or lamp knob; there are no
user-serviceable components inside.
WARNING
UV Light Hazard.
Harmful to bare skin and eyes.
Can cause temporary or permanent loss of vision.
Never look at the lamps while illuminated.
Only view illumination by way of the light indicator
located on the lamp knob.
To prevent exposure to ultraviolet light, disconnect
power to the ultraviolet air treatment system before
servicing any part of the heating/air conditioning
system.
CAUTION
UV Lamp Burn Hazard.
Harmful to bare skin.
Can cause severe burns.
Disconnect power and wait 15 minutes before
removing the ultraviolet lamp(s).
IMPORTANT
If the lamps in your model have external wires run-
ning along the glass surface, be sure to avoid pulling
on those wires.
CAUTION
Breakable Glass Hazard.
Can cause personal injury.
Be careful when inserting lamp(s) into lamp base.
Wear protective gloves when handling lamp(s).