Install Instructions

TP970-72, TP970-74, TP9600, AND TP9630 PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
INSTALLATION
This section categorizes stat installation according to the
following factors:
— Location of tubing: recessed or surface-mounted
— Type of wall: hollow-core studded, block or brick,
concrete, or mullion
— Condition of wall: rough-in or finished
Installation with Recessed Tubing
Examples of installations with recessed tubing include:
hollow-core stud walls, block or brick walls, concrete walls,
and mullions.
Hollow-Core Studded Wall
A hollow-core studded wall requires either rough-in mounting
or finished-wall installation.
Rough-In Installation
Rough-in installation is done to a stud before the wall is
drywalled or to lath before the wall is plastered.
NOTE: If the wall is already drywalled or plastered, see
FINISHED WALL INSTALLATION.
Mounting to Stud with Stud-Mounted Stat Plate
Mounting to a stud using a Stud-Mounted Stat Plate requires
the following equipment:
— Stud-Mounted Stat Plate 14004610-001 (Fig. 21)
— Extension Plate 14004656-001 (optional) (Fig. 21)
— Tape Measure CCT422
— No. 8 sheet metal screws
— Cordless Drill CCT713 (Fig. 22)
— TEK Drill Adapter Screwdriver CCT240 (Fig. 22)
— No. 8 x 1/2 in. TEK Screws CCT2444 (two per stat)
— Stud Mount Box Clip CCT2642 for mounting Stud-
Mounted Stat Plate to metal stud (Fig. 23) (optional)
— Thermostat Tool CCT735A (MQT735A)
SCREWS
PROVIDED
STUD-MOUNTED
EXTENSION PLATE
STAT PLATE
NOTE: MAXIMUM EXTENSION IS 2-3/4 IN. (70 MM) USING
C3932
ONE PLATE, 5-3/8 IN. (137MM) USING TWO PLATES.
Fig. 21. Stud-Mounted Stat Plate and
Optional Extension Plate.
TEK DRILL ADAPTER
SCREWDRIVER
CORDLESS DRILL
C3167
Fig. 22. TEK Drill Adapter Screwdriver and Cordless Drill.
C3181
Fig. 23. Stud Mount Box Clip.
TAPE
MEASURE
C3162
1. Measure and mark approximate stat location on stud.
9
95-5597—1