Install Instructions

TP970-72, TP970-74, TP9600, AND TP9630 PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
PHILLIPS END
THERMOSTAT
STEP/BORING
TOOL
CORDLESS
HAMMER
DRILL
SHALLOW
WALL PLATE
C3947
MOLLY ANCHORS (2)
b. If wall is drywall, Sheetrock, or plaster,
disassemble Molly anchors and reassemble
through appropriate corner holes of Shallow Wall
Plate (see inset). Tighten anchors slightly to
secure them to Shallow Wall Plate. Push anchors
through holes in wall. With protective sleeve over
bore of Thermostat Step/Boring Tool, use Phillips
end of Tool to tighten anchors.
TUBING
PROTECTOR
BARB
CAP
COUPLINGS
TUBING AND TWIN
ELBOW ASSEMBLY
PROTECTOR
ASSEMBLY
C3591
TUBING AND TWIN
ELBOW ASSEMBLY
STRAIN RELIEF
C3950
SHALLOW WALL PLATE
6. Remove screw from Shallow Wall Plate upper screw
receptacle. Push strain relief of Tubing and Twin Elbow
Assembly onto screw receptacle. Replace screw,
leaving it slightly backed out. Back out bottom screw.
TUBING AND TWIN
ELBOW ASSEMBLY
SHALLOW
WALL PLATE
WALL MOUNTING
RING
C3951
7. Use pocket knife to cut away web where indicated
inside Wall Mounting Ring (see inset). Place Wall
Mounting Ring over Shallow Wall Plate and Tubing and
Twin Elbow Assembly.
5. Remove protector cap and protector assembly from
Tubing and Twin Elbow Assembly. Attach tubing.
43
95-5597—1