Install Instructions

TP970-72, TP970-74, TP9600, AND PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS

SAMPLE ANCHOR

LOCATIONS

SHALLOW WALL PLATE

(ENDS BROKEN OFF)

3. If wall is:

a. Block, brick, or concrete, use Cordless Hammer

Drill and Masonry Drill to drill 3/16-in. (4.8-mm)

holes where marked. Tap Plastic Screw Anchors

into holes.

STEP

THERMOSTAT STEP/BORING TOOL

CORDLESS DRILL

C3184

2. Break off ends of Shallow Wall Plate. Center Shallow

Wall Plate over mark on wall. Mark anchor locations at

two opposite corners of Shallow Wall Plate.

b. Drywall, Sheetrock, or plaster, leave protective

sleeve over bore of Thermostat Step/Boring Tool

and use Drill and Tool to drill 1/4 in. (6 mm) holes

where marked (drill up to step on Tool).

C3169

C3196

CORDLESS

HAMMER DRILL

MASONRY

DRILL BIT

PLASTIC SCREW

ANCHOR (2)

3/16 IN.

(4.8 MM)

C3200

PLASTIC SCREW

ANCHOR (2)

SHALLOW

WALL PLATE

4. If wall is:

a. If wall is block, brick, or concrete, screw No. 8 x 3/4

in. Sheet Metal Screws through stat backplate and

into Plastic Screw Anchors.

95-5597—1