Install Instructions

TP970-72, TP970-74, TP9600, AND PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
STAT BACKPLATE
NO. 8 x 3/4 SHEET
METAL SCREW (2)
C4105
6. Position stat backplate against mullion. Level stat
backplate. Screw No. 8 x 3/4 in. Sheet Metal Screws
through stat backplate keyhole slots into mullion.
STAT BACKPLATE
S TAT
C3574
7. Mount stat to stat backplate.
SETSCREWS
STAT BACKPLATE
STAT
COVER
TAB (2)
C4111
SETSCREW SLOTS
8. Hook slots on stat cover over bottom tabs on stat
backplate. Swing stat cover up and over stat. Use
Thermostat Tool to raise stat backplate setscrews into
setscrew slots on top of cover.
Installation With Surface-Mounted Tubing
Installation with surface-mounted tubing requires the following
equipment:
— Shallow Wall Plate Assembly 14001615-001/-002 or
14001616-001/-002 (Fig. 43). Includes the following:
• Shallow Wall Plate 14001614-001
• Plaster Ring 14001609-001
• Fitting Finder 14000706-001
NOTE: Shallow Wall Plate Assembly 14001615-001 (one
pipe) or -002 (two pipe) has copper tubing.
Assembly 14001616-001 (one pipe) or -002 (two
pipe) has 5/32 in. (4 mm) O.D. plastic tubing.
— Tape Measure CCT422
— Wall Mounting Ring 14004458-001 (Fig. 44)
— Cordless Hammer Drill CCT712 (MQG773) (Fig. 45)
— If wall is block, brick, or concrete:
• Masonry Drill CCT773 (MQG773) (Fig. 45)
• Plastic Screw Anchors CCT2230 (MVH2230)
(two per stat)
• No. 8 x 3/4 in. Sheet Metal Screws CCT2306
(MVH2306) (two per stat)
— If wall is drywall, Sheetrock, or plaster:
• Thermostat Step/Boring Tool CCT691 (Fig. 45)
• Molly Anchors CCT2260 (MVH2260) (two per stat)
— Pocket knife
— Thermostat Tool CCT735A (MQT735A)
95-5597—1
40