Install Instructions

C
L
TP970-72, TP970-74, TP9600, AND PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
SETSCREWS
STAT
BACKPLATE
UNI-BIT
1/8 IN. HIGH SPEED
DRILL BIT
STAT
CORDLESS DRILL
TAB (2)
COVER
C3168
C4119
SETSCREW SLOTS
Fig. 42. Unit-Bit, 1/8 in. High-Speed Drill Bit,
and Cordless Drill.
9. Hook slots on stat cover over bottom tabs on stat
backplate. Swing stat cover up and over stat. Use
THERMOSTAT
Thermostat Tool to raise stat backplate setscrews into
MULLION
MOUNTING
setscrew slots on top of cover.
GUIDE TOOL
Mullion
Mounting to a standard metal mullion requires the following
equipment:
— Tape Measure CCT422 (Fig. 41)
— Thermostat Mounting Guide Tool CCT690 (Fig. 41)
— Fish Chain CCT417
— Wire hook for pulling Fish Chain through wall (see Step 4)
TAPE MEASURE
— Cordless Drill CCT713 (Fig. 42)
— Uni-Bit CCT230 (Fig. 42)
— 1/8 in. High-Speed Drill Bit CCT166 (MQG166) (Fig. 42)
— No. 8 x 3/4 in. Sheet Metal Screws CCT2306 (MVH2306)
— Thermostat Tool CCT735A (MQT735A)
BACK
VIEW
LEVEL
TAPE
MEASURE
1
C3192
THERMOSTAT
MOUNTING
GUIDE TOOL
1. Measure approximate stat location on mullion. Turn
Tape Measure sideways and mark center, top, and
bottom hole locations according to points on back of
Thermostat Mounting Guide Tool.
1
1—1/2 IN. (38 MM) FROM BOTTOM OF TAPE MEASURE TO
CENTER MARK CORRESPONDING TO CENTER OF STAT.
C3151
Fig. 41. Tape Measure and Thermostat Mounting Guide Tool.
95-5597—1
38