Install Instructions

TP970-72, TP970-74, TP9600, AND TP9630 PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
SOFT COPPER TIE
WIRE OR PLASTIC
COVERED WIRE TIE
STEEL
REINFORCEMENT
ROD
TAPED DEEP WALL BOX
POSITION SO THAT
FRONT OF BOX WILL
BE FLUSH WITH WALL
STAT BACKPLATE
DEEP WALL BOX
C3585
C3165
7. Back screws out of Deep Wall Box. Hook stat backplate
keyhole slots onto backed-out screws. Level stat
backplate and tighten screws.
5. Attach conduit or Cable Assembly to steel
reinforcement rods with Soft Copper Tie Wire or Plastic
Covered Wire Ties so that front of Deep Wall Box will
be flush with wall.
STAT BACKPLATE
C3577
S TAT
DEEP WALL BOX
STAT BACKPLATE
C3584
8. Mount stat onto stat backplate.
6. After concrete is poured and set, cut tape from front of
Deep Wall Box. Cut elbow from Cable Assembly, if
used. Connect tubing to barbs on stat backplate.
37
95-5597—1