Install Instructions

TP970-72, TP970-74, TP9600, AND TP9630 PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
C3582
DEEP WALL
BOX IN BLOCK
BRICK WALL
STAT
BACKPLATE
5. If Cable Assembly is used, cut elbow from end of
tubing. Connect tubing to barbs on stat backplate.
C3583
STAT BACKPLATE
DEEP WALL
BOX SCREW (2)
KEYHOLE
SLOT (2)
7. Mount stat to stat backplate.
8. Hook slots on stat cover over bottom tabs on stat
backplate. Swing stat cover up and over stat. Use
Thermostat Tool to raise stat backplate setscrews into
setscrew slots on top of cover.
Finished Wall Installation
This section describes finished wall installation with tubing
recessed in the openings inside the block or brick. To install a
stat where tubing is surface mounted, see SURFACE-
MOUNTED TUBING.
Finished wall installation requires the following equipment:
— Tape Measure CCT422 (Fig. 37)
— Thermostat Mounting Guide Tool CCT690 (Fig. 37)
— Fish Chain CCT417
— Wire hook for pulling Fish Chain through wall (see Step 4)
— 1/2 in. Hammer Drill CCT717 (MQG717) (Fig. 38)
— Masonry Drills CCT773 (MQG773) (3/16-in. bit) and
CCT786 (7/8-in. bit) (Fig. 38)
— 3/4 in. Plastic Screw Anchors CCT2230 (MVH2230)
(2 per stat)
— No. 8 sheet metal screws (2 per stat)
— Thermostat Tool CCT735A (MQT735A)
C
L
BACK
VIEW
LEVEL
THERMOSTAT
MOUNTING
GUIDE TOOL
TAPE
MEASURE
1—1/2 IN. (38 MM) FROM BOTTOM OF TAPE MEASURE TO
CENTER MARK CORRESPONDING TO CENTER OF STAT.
C3151
1
1
Fig. 37. Tape Measure and Thermostat Mounting Guide Tool.
6. Back screws out of Deep Wall Box. Hook keyhole slots
on stat backplate over backed out screws. Level stat
backplate and tighten screws.
31
95-5597—1