Install Instructions

TP970-72, TP970-74, TP9600, AND PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
STAT
BACKPLATE
C3170
STAT
7. Mount stat onto stat backplate.
SETSCREWS
STAT
BACKPLATE
STAT
SETSCREW
C4114
SLOTS
COVER
TAB (2)
8. Hook slots on stat cover over bottom tabs on stat
backplate. Swing stat cover up and over stat. Use
Thermostat Tool to raise stat backplate setscrews into
setscrew holes on top of cover.
Block or Brick Wall
A stat should be mounted according to the steps shown in
ROUGH-IN INSTALLATION. Use the procedure in FINISHED
WALL INSTALLATION only if the stat cannot be roughed in as
part of the wall. If the wall is to be plastered, see
INSTALLATION WITH SURFACE-MOUNTED TUBING.
Rough-In Installation
Rough-in is done by the mason as the wall is laid. The
installer hangs the stat at its approximate final location and
the mason cuts the hole where needed in the block course.
Rough-in installation may require some or all of the following
equipment:
— Deep Wall Box 14001355-001 (Fig. 35)
— One of the following (Fig. 36):
• Plastic Cable Assembly 14001491-001 (one pipe),
-002 (two pipe), or -003 (three pipe) and Barb
Couplings CCT1606B (MJP1606B) (5/32 x 1/4 in.) or
CCT1628B (MJP1628B) (5/32 x 5/32 in.)
• Copper Cable Assembly 14001494-001 (one pipe),
-002 (two pipe), or -003 (three pipe)
• 1/2 in. emt conduit and 1/2 in. TW Setscrew
Connector CCT2900 (MVE2900)
— Tape Measure CCT422
— Thermostat Tool CCT735A (MQT735A)
ALIGNMENT GUIDE
FOR FINISHED WALL
NO. 6–32 X 1/2 IN. SCREW (2)
C3185
PROVIDED WITH DEEP WALL BOX
Fig. 35. Deep Wall Box.
95-5597—1
28