Install Instructions

ManualsBrandsHoneywell ManualsCommercial Thermostats & ControlsPneumatic Thermostat Direct Acting, Wall Thermostat and Beige Cover (59° to 90°F setpoint range)

TP970-72, TP970-74, TP9600, AND PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS

Anchors

Drywall installation with anchors requires the following

equipment:

— Tape Measure CCT422 (Fig. 33)

— Thermostat Mounting Guide Tool CCT690 (Fig. 33)

— Cordless Drill CCT713 (Fig. 34)

WALL

— Thermostat Step/Boring Tool CCT691 (Fig. 34)

LEVEL ON

— Fish Chain CCT417

GUIDE

— Wire hook for pulling Fish Chain (see Step 3)

— Molly Anchors CCT2260 (MVH2260) (2 per stat)

— Thermostat Tool CCT735A (MQT735A)

TAPE

LEVEL

BACK

MEASURE

VIEW

TAPE

MEASURE

THERMOSTAT

MOUNTING

GUIDE TOOL

FLOOR

C3172

1. Measure thermostat location on wall. Use level on

1—1/2 IN. (38 MM) FROM BOTTOM OF TAPE MEASURE TO

Mounting Guide to ensure that Mounting Guide is plumb.

CENTER MARK CORRESPONDING TO CENTER OF STAT.

Tap Tape Measure to mark hole locations on wall.

C3151

Fig. 33. Tape Measure and Thermostat Mounting Guide Tool.

STEP

PROTECTIVE SLEEVE FOR BORE

3/4 INCH

REPLACEMENT PROTECTIVE SLEEVES

(19 MM)

ARE AVAILABLE. ORDER CCT691A.

THERMOSTAT STEP/BORING TOOL

1/4 INCH

(6 MM)

BORE

CORDLESS DRILL

C3174

WARNING

TO AVOID BODILY INJURY AND PROTECT

BORE, LEAVE PROTECTIVE SLEEVE ON

2. Drill holes where marked on wall. For top and bottom

STEP/BORING TOOL EXCEPT WHEN

holes, drill until the step of the Thermostat Step/Boring

DRILLING WITH BORE.

C3152

Tool meets wall. For center hole, remove protective sleeve

from bore, force Thermostat Step/Boring Tool beyond the

Fig. 34. Thermostat Step/Boring Tool and Cordless Drill.

step, and drill the hole with the bore. Replace protective

sleeve over bore.

95-5597—1