Install Instructions

ManualsBrandsHoneywell ManualsCommercial Thermostats & ControlsPneumatic Thermostat Direct Acting, Wall Thermostat and Beige Cover (59° to 90°F setpoint range)

TP970-72, TP970-74, TP9600, AND TP9630 PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS

PHILLIPS

END

THERMOSTAT

STEP/BORING

TOOL

BACKPLATE

ASSEMBLY

CORDLESS DRILL

C3183

7. Hold Backplate Assembly to appear plumb. With

protective sleeve over bore of Thermostat Step/Boring

Tool, drive anchors with Phillips end of Tool.

SHIPPING STOP(S)

C3178

9. Remove shipping stop(s) from Thermostat and Cover

Assembly. Place packing shell and shipping stop(s)

back in carton.

BACKPLATE

THERMOSTAT AND

C3176

ASSEMBLY

COVER ASSEMBLY

10. After painting is complete, use tear strip to remove

outer paint mask. Peel off inner paint mask.

BACKPLATE

THERMOSTAT AND

C3176

ASSEMBLY

COVER ASSEMBLY

8. Remove Thermostat and Cover Assembly from packing

shell. Align top of Thermostat and Cover Assembly with

top of Backplate. Snap Thermostat and Cover

Assembly onto Backplate Assembly.

25

95-5597—1