Install Instructions

ManualsBrandsHoneywell ManualsCommercial Thermostats & ControlsPneumatic Thermostat Direct Acting, Wall Thermostat and Beige Cover (59° to 90°F setpoint range)

TP970-72, TP970-74, TP9600, AND TP9630 PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS

Finished Wall Installation

In a finished wall installation, the studs are covered with

drywall or plaster and the tubing is behind the wall. Finished

wall installation is done with a Quick-Mount Thermostat,

anchors, or a Shallow Wall Plate.

Quick-Mount Thermostat

Installing a Quick-Mount Thermostat requires the following tools:

GUIDE

— Tape Measure CCT422 (Fig. 31)

— Thermostat Mounting Guide Tool CCT690 (Fig. 31)

— Cordless Drill CCT713 (Fig. 32)

— Thermostat Step/Boring Tool CCT691 (Fig. 32)

TAPE

MEASURE

— Fish Chain CCT417

— Wire hook for pulling Fish Chain (see Step 3)

1. Measure thermostat location on wall. Use level on

Mounting Guide to ensure that Mounting Guide is

plumb. Tap Tape Measure to mark hole locations.

STEP

Fig. 31. Tape Measure and Thermostat Mounting Guide Tool.

3/4 INCH

(19 MM)

1/4 INCH

(6 MM)

BORE

CORDLESS DRILL

C3174

Fig. 32. Thermostat Step/Boring Tool and Cordless Drill.

BACK

VIEW

LEVEL

THERMOSTAT

MOUNTING

GUIDE TOOL

TAPE

MEASURE

1—1/2 IN. (38 MM) FROM BOTTOM OF TAPE MEASURE TO

CENTER MARK CORRESPONDING TO CENTER OF STAT.

C3151

WALL

C3172

LEVEL ON

FLOOR

THERMOSTAT STEP/BORING TOOL

CORDLESS DRILL

C3152

PROTECTIVE SLEEVE FOR BORE

REPLACEMENT PROTECTIVE SLEEVES

ARE AVAILABLE. ORDER CCT691A.

TO AVOID BODILY INJURY AND PROTECT

BORE, LEAVE PROTECTIVE SLEEVE ON

STEP/BORING TOOL EXCEPT WHEN

DRILLING WITH BORE.

WARNING

! !

2. Drill holes where marked on wall. For top and bottom

holes, drill until the step of the Thermostat Step/Boring

Tool meets wall. For center hole, remove protective

sleeve from bore, force Thermostat Step/Boring Tool

beyond the step, and drill the hole with the bore. Replace

protective sleeve over bore.

95-5597—1