Manualshelf

Install Instructions

ManualsBrandsHoneywell ManualsCommercial Thermostats & ControlsPneumatic Thermostat Direct Acting, Wall Thermostat and Beige Cover (59° to 90°F setpoint range)
21222324252627282930
TP970-72, TP970-74, TP9600, AND PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
STAT
BACKPLATE
TWIN ELBOW
CONNECTOR
STAT
BACKPLATE
PLASTER RING
IN WALL
C3595
7. After plaster is up, remove Fitting Finder from Plaster
Ring. Remove protector from end of tubing, leaving
Twin Elbow Connector. Connect Twin Elbow Connector
to barbs on stat backplate.
9.
STAT
Mount Stat to stat backplate.
C3578
BACKED-OUT
SCREW (2)
STAT
BACKPLATE
SETSCREWS
STAT
STAT
BACKPLATE
KEYHOLE
SLOTS
TAB (2)
C3596
COVER
8. Back screws out of Plaster Ring. Slip stat backplate
keyhole slots over screws. Level stat backplate and
tighten screws.
10. Hook slots on stat cover over bottom tabs on stat
backplate. Swing stat cover up and over stat. Use
Thermostat Tool to raise stat backplate setscrews into
setscrew slots on top of cover.
C4118
SETSCREW SLOTS
95-5597—1
22