Install Instructions
TP970-72, TP970-74, TP9600, AND PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
Mounting to Lath
Mounting to lath requires the following equipment:
— Shallow Wall Plate Assembly 14001615-001/-002 or
14001616-001/-002 (Fig. 30). Includes the following:
• Shallow Wall Plate 14001614-001
• Plaster Ring 14001609-001
• Fitting Finder 14000706-001
NOTE: Shallow Wall Plate Assembly 14001615-001 (one
pipe) or -002 (two pipe) has copper tubing.
Assembly 14001616-001 (one pipe) or -002 (two
pipe) has 5/32 in. (4 mm) O.D. plastic tubing.
— Tape Measure CCT422
— Barb Couplings CCT1606B (MJP1606B) (5/32 x 1/4 in.)
or CCT1628B (MJP1628B) (5/32 x 5/32 in.) for plastic
tubing (one, two, or three Couplings required according
to application)
— Soft Copper Tie Wire CCT2643 or Plastic Covered Wire
Ties CCT2663 (MVE2663)
— Wall Mounting Ring 14004458-001
— Thermostat Tool CCT735A (MQT735A)
SHALLOW WALL
PLATE BOTH ENDS
PROTECTOR CAP
ARE REMOVABLE
8 FT (2.5 M)TUBING
AND TWIN ELBOW
ASSEMBLY
1
PLASTER RING
1
FITTING FINDER
PRESS TO SNAP
IN PLACE
1
AVAILABLE SEPARATELY
C3597
Fig. 30. Shallow Wall Plate Assembly.
TAPE
MEASURE
C3170
1. Measure and mark approximate stat location on lath.
SOFT COPPER TIE WIREOR
PLASTIC COVERED WIRE TIES
C3187
2. At approximate stat location, anchor corners of Shallow
Wall Plate to lath with Soft Copper Tie Wire or Plastic
Covered Wire Ties.
95-5597—1
20