Install Instructions

TP970-72, TP970-74, TP9600, AND TP9630 PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
DEEP WALL
BOX
STAT
BACKPLATE
KEYHOLE
SLOTS
C3587
6. Back screws out of Deep Wall Box. Hook stat backplate
keyhole slots onto backed-out screws. Level stat
backplate and tighten screws.
STAT
BACKPLATE
STAT
C3575
SETSCREWS
STAT
BACKPLATE
STAT
TAB (2)
COVER
SETSCREW
SLOTS
C4115
8. Hook slots on stat cover over bottom tabs on stat
backplate. Swing stat cover up and over stat. Use
Thermostat Tool to raise stat backplate setscrews into
setscrew slots on top of cover.
Mounting to Stud with Standard Electrical Box
Mounting to a stud using a standard electrical box requires
the following equipment:
— Standard Utility Conduit Box CCT2967 (MVE2967) or
Standard 4 x 4 in. Electrical Box CCT2960 (Fig. 27)
— One of the following (Fig. 28):
• Plastic Cable Assembly 14001491-001 (one pipe),
-002 (two pipe), or -003 (three pipe) and Barb
Couplings CCT1606B (MJP1606B) (5/32 x 1/4 in.) or
CCT1628B (MJP1628B) (5/32 x 5/32 in.)
• Copper Cable Assembly 14001494-001 (one pipe),
-002 (two pipe), or -003 (three pipe)
• 1/2 in. emt conduit and 1/2 in. TW Setscrew
Connector CCT2900 (MVE2900)
— Tape Measure CCT422
— No. 10 x 3 Pan Head Sheet Metal Screws CCT2317
(MVH2317) or 2-1/2 in. (64 mm) nails (two per stat)
— Stud Mount Box Clip CCT2642 for Standard Utility
Conduit Box (Fig. 29)
— MFS Clip CCT2649E for Standard 4 x 4 in. Electrical Box
(Fig. 29)
— If wall is to be plastered:
• Standoff Ring 14000885-001
• Fitting Finder 14000706-001
— Thermostat Tool CCT735A (MQT735A)
7. Mount stat onto stat backplate.
15
95-5597—1