Install Instructions

TP970-72, TP970-74, TP9600, AND PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
STUD
CABLE
ASSEMBLY
DEEP WALL BOX
NO. 8 x 2 IN.
SHEET METAL SCREWS
OR 6d 2 IN. (51 MM) NAILS
MOUNTING DEEP WALL BOX DIRECTLY TO STUD
NO. 8 x 1/2 IN. TEK SCREW
UNIVERSAL STRAP
DEEP WALL BOX
8-32 x 1/2 IN. ROUND HEAD SCREW
(INSTALL FROM INSIDE BOX)
NO. 8 x 1/2 IN.
TEK SCREW
MOUNTING DEEP WALL BOX BETWEEN STUDS
USING UNIVERSAL STRAP
DEEP WALL BOX DEEP WALL BOX
NO. 8 TEK
NO. 8 TEK
SCREWS (2)
SCREWS (2)
DEEP
WALL BOX
DEEP
MOUNTING
WALL BOX
BRACKET
MOUNTING
1 (25)
OFFSET
2 (51)
BRACKET
OFFSET
ALIGN BRACKET NOTCH
C3939
WITH EDGE OF STUD
USING DEEP WALL BOX MOUNTING BRACKET
3. Mount Deep Wall Box to stud so that front of Box will be
flush with finished wall.
BARB
COUPLINGS
PROTECTOR CAP
PLASTIC CABLE
ASSEMBLY 8 FT (2.5 M)
FITTING FINDER
C3561
(IF WALL IS TO BE PLASTERED)
4. Remove protector cap from Cable Assembly. Attach
tubing to Cable with 5/32 x 1/4 in. or 5/32 x 5/32 in.
Barb Couplings. If wall is to be plastered, snap Fitting
Finder onto Deep Wall Box.
TUBING
STAT
BACKPLATE
C3590
5. After drywall or plaster is up, remove Fitting Finder, if
used, from box. Cut elbow from end of Cable Assembly.
Connect tubing to barbs on stat backplate.
95-5597—1
14