Install Instructions

TP970-72, TP970-74, TP9600, AND PNEUMATIC SENSORS, HUMIDISTATS, AND THERMOSTATS
HORIZONTAL MOUNTING TO HORIZONTAL STUD
HORIZONTAL MOUNTING TO VERTICAL STUD
OR VERTICAL MOUNTING TO HORIZONTAL STUD
OR
VERTICAL MOUNTING TO VERTICAL STUD
STUD MOUNT
BOX CLIP
MOUNTING TO METAL STUD
(REQUIRES STUD MOUNT BOX CLIP CCT2642)
TEK SCREW (2)
EXTENSION PLATE
NOTE:
TO ATTACH STUD-MOUNTED STAT PLATE TO EXTENSION PLATE:
SHEET METAL SCREW (2)
A. FIT TWO BUTTONS ON EXTENSION PLATE INTO SLOTS
ON STUD-MOUNTED STAT PLATE.
EXTENSION PLATE
BUTTON (2)
B.
ALIGN TWO OUTER HOLES AND/OR SINGLE CENTER
HOLES ON TWO PLATES.
STUD-MOUNTED
C.
FASTEN PLATES TOGETHER WITH NO. 8 x 1/2 IN.
STAT PLATE
SHEET METAL SCREWS.
D.
FASTEN EXTENSION PLATE TO STUD USING
NO. 8 x 1/2 IN. TEK SCREWS.
C3937
TYPICAL MOUNTING WITH EXTENSION PLATE
2. Attach Stud-Mounted Stat Plate, using Extension Plate if required to center stat over electrical box. Use Cordless Drill and
TEK Screwdriver Drill Adapter to drive No. 8 x 1/2 in. TEK screws, or use Stud Mount Box Clip as required.
95-5597—1
10