User manual

Room Temperature Sensor (HCF82 or HCW82)
1
Remove the cover from the sensor
2
Press and hold the bind button until the red
LED goes off (approx 30 seconds)
3
The red LED will flash each time it sends a test message
The Central Controller will display the signal strength (poor
to excellent) – no flashing means the Temperature Sensor
has not received a test signal from the Central Controller.
4
To exit test mode, press the bind button
on the Temperature Sensor. It will exit
automatically after 5 minutes.
1 2
PRESS FOR
30 SECONDS
Advanced RF communication check continued
P34 Step 4: System test