User manual

Power up and bind a Wireless Cylinder
Thermostat Transceiver (CS92)
On the CS92 Transceiver
1
Remove the CS92 Transceiver cover
2
Remove the battery tab and replace the cover
3
On the CS92 Transceiver press and hold the
button for 5 seconds. The green light should
come on and the red light should flash
4
Press the button again
5
You should receive a SUCCESS message on the
Central Controller (if not go back and re-bind)
6
Choose the correct hot water valve type for the system
you’re installing and follow the on screen instructions
If you are NOT following
GUIDED CONFIGURATION
follow these steps on your
Central Controller display
first:
1. Press and hold
“Settings”
for 3
seconds
2. Press the green tick
3. Select GUIDED
CONFIGURATION
4. Press STORED
HOT WATER
CONFIGURATION
5. Press the green tick
Central
Controller
HOLD
5 SEC
PRESS
ONCE
3
1 12
PULL TAB
Wireless Cylinder Thermostat (CS92)
P16 Step 3: Power up and bind devices