User manual

First, power up the Central Controller
1
Remove the cover, remove the battery
tab and replace the cover
2
Place it on the table stand or wall bracket
3
Once the batteries are fully charged, the Central
Controller can be easily removed from the table stand or
wall bracket for ease of programming. After 30 minutes
the Central Controller will emit a beep to indicate that
it should be replaced on the stand or wall bracket
Your Central Controller
comes with *rechargeable
batteries which are
pre-charged allowing
you to set-up the system
while off the table stand
or wall bracket.
Place the Central Controller
on the table stand or wall
bracket for normal use.
*Only use the
AA rechargeable
batteries provided
!
1
PULL TAB
Powering up your Central Controller
P10 Step 2: Set up evotouch