Prestige Equipment Interface Module Installation Guide

12
Making changes to Installer Setup and performing Installer Test
Mounting outdoor and indoor sensors
Follow these steps to set system options after initial installation.
NOTE: Use a USB device to save set up time. See page 14.
1 Touch Menu.
2 Select Installer Options.
3 Enter password (date code)
and touch Done.
4 Select Create Setup or Installer Test.
5 Follow prompts on the screen to
select the desired setup options
or to perform an equipment test.
Installer Opons
Done
Mounting an outdoor sensor
1 Mount the sensor on a vertical
exterior wall, at least 6 inches below
any overhang. Choose a location
protected from direct sunlight.
2 Place sensor securely in bracket,
facing away from wall.