VisionPRO 8000 Spec Sheet 2017

VISIONPRO
®
8000 WITH REDLINK™
75 68-0312—05
Fig. 157. Wiring dry contact devices.
1. Wire the dry contact device to S1, S2, S3 or S4 termi-
nals at the EIM.
2. Enter Installer Setup (see “Make Changes to Installer
Setup” beginning on page 21).
3. Dry Contacts are selected at ISU 600. Select the
appropriate Dry Contact(s) and press Next.
Fig. 158.
4. Select the terminals wired to the Dry Contact device,
and press Next.
Fig. 159.
5. Select Normally Open or Normally Closed, and press
Next.
NOTE: For example, if a wet switch is normally open,
it will close when the device detects water. If
the wet switch is normally closed, it will open
when the device detects water.
Refer to the instructions packed with the dry
contact device to determine if it is normally
open or normally closed.
Fig. 160.
6. If you are creating a custom alert, type the alert name
and press Done. The alert name is what appears on
the Home screen when the alert is detected. See Fig.
161. You can edit or confirm the alert name after you
enter it.
Fig. 161.
7. Type the custom alert message and press Done. The
custom alert message appears after selecting the
alert and pressing "View More Info". See Fig. 162. You
can edit or confirm the alert message after you enter
it.
MULTIPLE DRY CONTACT DEVICES
ON ONE SET OF TERMINALS
EIM
ONE DRY CONTACT DEVICE
MULTIPLE DRY CONTACT DEVICES
ON ONE SET OF TERMINALS
EIM
ONE DRY CONTACT DEVICE
S4
S4
S3
S3