Submittal Sheet

FOR FAN COIL/HEAT PUMP/CONVENTIONAL SYSTEMS
Automation and Control Solutions
Honeywell International Inc.
1985 Douglas Drive North
Golden Valley, MN 55422
customer.honeywell.com
® U.S. Registered Trademark
© 2016 Honeywell International Inc.
31-00096—02 M.S. 07-16
Printed in United States
By using this Honeywell literature, you agree that Honeywell will have no liability for any damages arising out of your use or
modification to, the literature. You will defend and indemnify Honeywell, its affiliates and subsidiaries, from and against any
liability, cost, or damages, including attorneys’ fees, arising out of, or resulting from, any modification to the literature by you.
Mounting
The thermostat consists of a front cover and back plate.
The device is wired on the back plate where the terminals
are located. Indicator arrows on the back plate will show
the proper orientation of the device. To prevent damage
during installation, align the pins on the front cover with
the terminal blocks for proper assembly.
NOTE: The thermostat must be mounted in a position
that allows clearance for wiring, servicing, and
removal.
NOTE: For complete mounting information, refer to the
Installation Instructions, form 31-00093.
Fig. 1. BACnet FF thermostat front cover,
dimensions in in. [mm].
Fig. 2. BACnet FF thermostat back plate,
dimensions in in. [mm].
N
IAGARA FRAMEWORK® and the Niagara framework logo are registered trademarks of Tridium, Inc.
BACnet
®
is a registered trademark of ASHRAE.
BTL
®
is a registered trademark of BACnet International.