Submittal Sheet

T775L SERIES 2000 CTLR 3. PROGRAMMING OUTPUT (LOOPS AND ADDITIONAL RELAYS) WITH RESET
62-0257–05 30
Fig. 74. Program - Sensor.
3.5.3. SENSOR
1. From the menu, use the S and T buttons to high-
light SENSOR.
2. Press the X button to display the sensor selections.
3. Use the S and T buttons to select Sensor A or B.
4. Press the X button to accept the highlighted sensor
and display the next option.
Fig. 75. Program - Heat/Cool Selection.
3.5.4. HEAT/COOL
1. From the menu, use the S and T buttons to high-
light HEAT/COOL.
Default: HEAT
2. Press the X button to display the heat and cool
selections.
3. Use the S and T buttons to select Heat or Cool.
4. Press the X button to accept the highlighted selec-
tion and display the next option.
Fig. 76. Program - Setback (Offset).
3.5.5. SETBACK OFFSET
The Setback temperature option displays only if
scheduling is enabled (see Fig. 31 on page 15) or the DI
Option is set to Setback. (see Fig. 33 on page 16).
This value is the number of degrees plus (+) or minus (-)
that you want the temperature to be offset from this relay’s
setpoint.
For example, If you want the temperature to be 10°F less
than the relay’s setpoint during setback mode, enter
-10°F. In normal operations for heating, the offset will be
negative. For cooling, the offset will be a positive value.
1. From the menu, use the S and T buttons to high-
light SETBACK.
2. Use the S and T buttons to increase/decrease the
desired setpoint temperature.
Default: 0°F
Range: -150°F to 150°F (-101°C to 66°C)
3. Press the X button to accept the value and display
the menu.
3.6. Program Next Relay
If you have a second relay output, select that relay from
the Program menu, and go to “3.5. Program Menus for
the Additional Relays with Reset” on page 29.
When you finish programming the relay outputs, continue
with “3.7. Exit Programming with Reset”.
3.7. Exit Programming with Reset
Press the HOME button to leave programming mode and
return to the home screen.
This completes the programming procedure for the
additional relays that use Reset.
MENU
PROGRAM
RELAY 9
SENSOR
SELECT
SENSOR
FOR
RELAY 9
SENSOR A
SENSOR B
PROGRAM
RELAY 9
SENSOR
M24417
PROGRAM
RELAY 9
HEAT/COOL
MENU
PROGRAM
RELAY 9
HEAT/COOL
SELECT
HEAT/COOL
FOR
RELAY 9
HEAT
COOL
M24418
PROGRAM
RELAY 9
SETBACK
MENU
PROGRAM
RELAY 9
SETBACK
-10
F
o
ENTER
SETBACK
OFFSET
FOR
RELAY 9
M24419