Submittal Sheet

1. SETUP T775L SERIES 2000 CTLR
21 62-0257–05
Fig. 47. Setup - Outputs - Relay - Reset.
1.3.5.2. RESET (Relay Reset)
This selection enables or disables reset for the selected
relay.
IMPORTANT
To use the Reset function of the controller, the
first Loop must be set for Reset.
1. Press the X button to display the Reset values.
2. Use the S and T buttons to select YES or NO.
Default: NO
3. Press the X button to accept the value and return to
the Relay menu.
• If you select YES, then the second relay (if available)
displays this Setup option and uses the reset curve
programmed for the first output Loop.
• If you select NO, then No Reset is configured for the
remaining relay output.
Fig. 48. Setup - Outputs - Relay - Reset Runtime.
1.3.5.3. RESET RT (Run Time)
This selection displays only if “Show RT = YES” is
selected during Output Options setup (see page 16).
1. Press the X button to display the Reset RT values.
2. Use the S and T buttons to select YES or NO.
Default: NO
3. Press the X button to accept the value and return to
the Relay menu.
Selecting YES immediately resets the output run time
hours to zero for this output. When you subsequently
return to this screen, the RESET RT defaults to NO.
NOTE: Run times can be reset to zero for each of the
first four independent relays. You must do this for
each relay that you want to reset to zero.
Fig. 49. Setup - Outputs - Relay - Exit.
1.3.5.4. Exit Relay Setup
Press the W button to exit the selected relay set up and
return to the Outputs menu.
To setup the next additional relay output go to “1.3.5.
Setting up the Relays” on page 20.
If you are finished setting up the additional relay outputs,
continue with “1.4. Exiting Setup”.
Fig. 50. Setup Exit.
1.4. Exiting Setup
Press the HOME button to exit Setup mode and return to
the home screen display. Or, use the S and T buttons to
highlight EXIT from the menu and press the X button.
This completes the Setup procedure. Continue with one
of the following sections depending on whether reset is
used:
• See “2. Programming Output (Loops and Additional
Relays) with No Reset” on page 22.
• See “3. Programming Output (Loops and Additional
Relays) with Reset” on page 24.
SETUP
OUTPUTS
RELAY 9
RESET
USE
RESET
FOR
RELAY 9
YES
NO
SETUP
OUTPUTS
RELAY 9
RESET
M24456
SETUP
OUTPUTS
RELAY 9
RESET RT
SETUP
OUTPUTS
RELAY 9
RESET RT
RESET
RUN TIME
FOR
RELAY 9
YES
NO
M24457
SETUP
OUTPUTS
RELAY 9
RESET
SCHEDULE
RESET RT
EXIT
M24458
SETUP
APP TYPE
SENSORS
OUTPUTS
EXIT
M24459