Submittal Sheet

7800 SERIES S7800A2142 KEYBOARD DISPLAY MODULE
32-00110—05 10
For pages that allow user input (see Fig. 10) the input value is edited on the page and then is acknowledged or confirmed
at another tab position on the page ("Yes" tab in the above example). This confirmation action permits the user to cancel
the editing and not commit to the change or to accept the edited value.
Home Page
The Home page is the main status page that displays primary status of the burner control operation (see Fig. 11). This
page is intended to be the primary one displayed most often when the user is not specifically looking for other
information or configuring the display. The following information is displayed by default:
• Burner control sequence or lockout state
• Flame signal strength
• Total cycles count
• Total run-time hours count
• Annunciator connection status
• Remote command status
The burner control sequence state may be displayed in one or two lines due to the length of the text. In case of two lines
the remaining lines are pushed down to make room for the second line.
This page also permits navigation to the following pages:
• Lockout message (when burner control is in a lockout condition)
•Fault history
• Burner control diagnostic status
• Annunciator diagnostic status (when annunciator is connected)
• Burner control commissioning (supported models only)
•Display menu
Fig. 11. Home page status
An additional status line can be displayed between the burner control sequence line(s) and the flame signal strength line
when configured (see “Selected Status Message” on page 37). Fig. 12 shows an example with the T6 terminal (“Demand”)
status displayed.
Fig. 12. Home page selected status
The lines are scrollable using the up and down arrows. For lines that navigate to another page the right arrow or OK
button is pressed when the line has input focus (highlighted) to go to the new page.
MAY BE 1 OR 2
LINES (SEQUENCE
STATE)
GO TO FAULT
HISTORY
GO TO
COMISSIONING (ONLY
SOME MODELS)
GO TO DISPLAY
MENU
GO TO BURNER
DIAGNOSTICS
OPTIONAL
SELECTED
STATUS