Installation Guide

17
2.3 Make sure your thermostat is
connected
While the connection is in process, your
thermostat will flash Waitforupto3minutes.
When the connection is complete, the
display will show Wi-Fi Setup Connection
Success. The Wi-Fi signal strength will
appear in the top-right corner.
After about 60 seconds, the home screen
will appear and Register at Total Connect
will flash until Step3 (registration) is
complete.
Note: If the thermostat displays Connection
Failure or continues to display Wi-Fi Setup,
confirm you correctly entered your home
network password in step 2.2c. If correct,
refer to the FAQ at wifithermostat.com/support
M33876
M33875