User Manual

RAE Systems by Honeywell
équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement
d'une communication satisfaisa
Caution2:
The module is limited to OEM installation ONLY.
OEM integrators are responsible for ensuring that the end-user has no manual
instructions to remove or install module.
The module is limited to installation in mobile or fixed applications, according to
Part 2.1091(b).
Separate approval is required for all other operating configurations, including
portable configurations with respect to Part 2.1093 and different antenna
configurations.
Authorized antennas per Part 15.204 (including ant. spec.).
Antenna installation requirements, where relevant.
A separate section should clearly state “FCC RF Exposure requirements:” (For
example: The antenna used with this module must be installed to provide a
separation distance of at least 20cm from all persons, and must not transmit
simultaneously with any other antenna or transmitter.)
Labeling instructions of finished products. Please refer to KDB 784748 (the
required instructions. Example: “Contains Transmitter Module FCC ID: RMBLED”
or “Contains FCC ID: RMBLED.
Caution3:
The host product shall be properly labelled to identify the modules within the host
product.
The ISED certification label of a module shall be clearly visible at all times when
installed in the host product; otherwise, the host product must be labelled to
display the ISED certification number for the module, preceded by the word
“contains” or similar wording expressing the same meaning, as follows;
Contains IC: 20969-RMBLED
In this case, 20969-RMBLED is the module’s certification number.
For each certified module, the applicant shall provide the user with a host label
as described above, or a description of the host product labelling requirements.