User Manual

60 PM45 and PM45c User Guide
5. Detach the magnetic pressure arm from the printhead bracket and disconnect
the two cables from the printhead as you remove it from the printer.
6. Connect the two printhead cables to the new printhead.
7. As you insert the new printhead bracket into the printer, make sure the metal
arms on the printhead go around the magnetic pressure arm bar. Attach the
magnetic pressure arm to the printhead.
8. Replace the media (and ribbon) in the printer.
9. Turn the printhead lift lever clockwise to lower it.
Replace the Platen Roller
If the printer platen roller gets damaged or wears out, it may need to be replaced.
1. Turn the printer off and disconnect the printer from power.
2. Open the media cover.
3. Remove the media.