Specification

INSTALLATION (SUPER
TR AD ELINE/TRADELINE shown)
The slotted kno ck outs on the b ot tom of the case and
the strain
relief bushing are provided to simpli fy the
installation procedure and to protect the wires.
1. To remove the slotted knockout(s), use a long-
nose pliers as shown in Fig . 6 and pull straight down .
FIG. 6-REMOVING SLOTTED KNOCKOUTS.
2. Insert the strain relief bushing into the knocko ut
as shown. The
op en side of the bushing should face the
open side of the knockout.
FIG. 7-INSERT STRAIN RELIEF BUSHING.
3. Connect wire to the push-in terminals, pull wires
thr ough slot. and lay s ide by side.
4. When the wires have been
connected to the
control, close the movable gate on the strain relief
bushing. Use a channel lock pliers to snap the gate shut
{Fig. 8).
6
FIG. 8-CLOSING THE STRAIN RELIEF BUSHING.
When connecting cable or conduit to this c ontrol,
use care to avoid strain on the control case. When
conne
cting w ir es to the push -in terminals, use the
followi ng
proc edure :
1. No. 14, 16, or
18 solid or No. 14 or 16 stranded
wire may be
connected to the terminals.
2. Strip insulation from wires the distance shown by
the st rip gauge on the controller.
3. Solid wire may be inserted by pushing i nt o the
terminal holes. If stra nded wire is used, inse rt a small
screw driver into the slot next to the terminal (Fig. 9).
Push in and hold while inserting wire in terminal. Then
remove screwdriver. Stranded wire may be pushed
directly in if solder dipped .
~ ~ ~~~~~IMPORTA N T~~~~~~ ......
A ll wires must be clear of rota ting scaleplat e.
FAN OFF
INDICATOR
FAN ON
INDI C ATOR
1
t;:::::;:···
\ .... ,,,'
v···· ~-- ·:.~NT!C :i" /• _ Ti; - :{ WlHFS 1'0 TEM PE F-lATUHE
~j \(O NTHOL C!HUJIT L4064T ONLY
"
FIG. 9-INTERNAL VIEW OF L4064, SHOWING USE
OF SCREWDRIVER TO CONNECT OR
DIS-
CONNE CT WIRES AT PUSH-IN TERMINALS.
NOTE: BECAUSE
THE DIAL TURNS WHEN
THE ELEMENT
TEMPERATURE CHANGES,
THE LETTERING
ON THE DIAL MAY NOT
BE HORIZONTAL