User manual

4 - 11
When using Preferred Symbology (page 4-17), a lower priority symbol must be centered on the aiming pattern to be read in
Streaming Presentation Mode.
Note: If you are using a cordless charge base, it must have an external power supply plugged into the aux port for Streaming
Presentation to work properly.
Streaming Presentation In-Stand Programming
This option is available when using In-Stand Sensor Mode, page 4-9. You may program a specific Streaming Presentation
Mode for in-stand scanning, and a Manual Trigger mode for out-of-stand scanning. To do this, you must first scan the pre-
ferred Streaming Presentation mode (Normal, Enhanced, or Mobile Phone), then scan the Manual Trigger mode (Normal,
Enhanced, or Mobile Phone) you want to use.
Mobile Phone Read Mode
When this mode is selected, your scanner is optimized to read bar codes from mobile phone or other LED displays. However,
the speed of scanning printed bar codes may be slightly lower when this mode is enabled. You can enable Mobile Phone Read-
ing for either a hand held device, or for a hands-free (presentation) application.
Note: Granit 1980i and 1981i do not support these settings.
Note: To turn off Mobil Phone Read Mode, scan a Manual or Serial Trigger Mode bar code (see page 4-6).
Hands Free Time-Out
The Scan Stand and Presentation Modes are referred to as “hands free” modes. If the scanner’s trigger is pulled when using a
hands free mode, the scanner changes to manual trigger mode. You can set the time the scanner should remain in manual trig-
ger mode by setting the Hands Free Time-Out. Once the time-out value is reached, (if there have been no further trigger pulls)
the scanner reverts to the original hands free mode.
Scan the Hands Free Time-Out bar code, then scan the time-out duration (from 0-300,000 milliseconds) from the inside back
cover, and Save. Default = 5,000 ms.
Reread Delay
This sets the time period before the scanner can read the same bar code a second time. Setting a reread delay protects against
accidental rereads of the same bar code. Longer delays are effective in minimizing accidental rereads. Use shorter delays in
applications where repetitive bar code scanning is required. Reread Delay only works when in a Presentation Mode (see page
4-7). Default = Medium.
Hand Held Scanning - Mobile
Phone
Streaming Presentation -
Mobile Phone
Hands Free Time-Out
Short (500 ms)