User manual

5 - 3
When in Streaming Presentation Mode, the scanner’s aimer goes out after a short time, but the scan illumination remains on all
the time to continuously search for bar codes (see Streaming Presentation™ Mode on page 4-10). When in Temporary
Streaming Presentation Mode, pressing the page button on the base puts the scanner into Streaming Presentation Mode until
the timeout occurs. If a bar code is scanned before the timeout is reached, the timer starts over.
When the scanner is in the base, press the page button once to put the scanner into Temporary Streaming Presentation
Mode. When the scanner is in the base and the base has external power (plugged into an outlet), press the page button twice
to put the scanner into Streaming Presentation Mode. Press it twice again to end Streaming Presentation Mode. When the
base does not have external power, pressing the page button twice does not trigger Streaming Presentation Mode.
When the scanner is out of the base, the page button works normally. Default = Temporary Streaming Presentation Mode On.
To remove Temporary Streaming Presentation Mode, scan the bar code for * Paging Mode On on page 3-7.
Temporary Streaming Presentation Timeout
Set a timeout for the length of time the illumination remains on and searching for bar codes when using Temporary Stream-
ing Presentation Mode. Set the length for the timeout by scanning one of the bar codes below. Default = 10,000 ms (10
seconds).
Quiet Operations - LED and Volume Settings
If you have silenced or muted the scanner and base sounds, you may wish to adjust the visual (LED) indicators for Bluetooth
linking sounds, scanning sounds, paging sounds, and out of range alarm sounds.
Linking LED Colors and Sound
Note: This setting is not supported by the Xenon 1900h scanner.
Under normal operations, the scanner chirps when linking to a base or an access point, and the LED on both the base and
scanner flash green. If you want to silence all sounds and set both devices to flash red LEDs to indicate the linking status,
scan the Red LED Flashes/Silent bar code below. The LEDS flash red while linking, then green to indicate the base and
scanner are linked. To return to the default LED colors and sound, scan Green LED Flashes/Sound. Default = Green
LED Flashes/Sound.
* Temporary Streaming Presentation Mode On
*10 Second Timeout
60 Second Timeout
* Green LED Flashes/Sound
Red LED Flashes/Silent