User manual

3 - 31

Creating a Configuration File Using the ReM Installer

Since the ReM Client Agent is already installed on the host, you do not need to go through the entire

installation process. However, you can use the ReM installer window to generate a configuration file:

1. Start the ReM installer on the scanner’s host (see page 2-4).

2. Complete all fields including the Licensing Tool (see page 2-8).

3. Click Save Install Configuration.

4. Select C:\Program Files\JPOSScaner\ReMLicensingTool then click Save. (This file will be

named ReM.config.)

5. Click Cancel to exit the ReM installer.

Note: Do not click Install.

6. Rename the ReM.config file you just created to RemApnt.config.

7. Open RemApnt.config.

8. Reformat the file so that it follows the layout required by the licensing process (see Basic Layout on

page 3-30).

Example:

You have used the ReM installer window to save the install configuration for a MS7580 scanner. The

ReM.config file generated will be formatted for use with the Silent Installer (see page 2-12):

ReMConfig>

etc...

You would then rename the file RemApn.config and reformat it as follows, removing any unneeded

data:

[ReM License]

ScannerName=MS7580 Genesis

ScannerID=13

FirmwareMain=No_Number

FirmwareMainPath=C:\Program Files\JPOSScanner\ReMLicensingTool\

P15978_STD.fwz

FirmwareCoprocessor=No_Number

FirmwareCoprocessorPath=C:\Program Files\JPOSScanner\ReMLicensingTool\

40486-40487.HEX

GoldenSettingPath=C:\Program Files\JPOSScanner\ReMLicensingTool\

ms7580.mst

IsFlashMainprocessor Whether you want the main firmware updated during the licensing pro-

cess. Required.

Possible values: yes or no.

Item Description