User manual

3 - 10
Find Page
Note: With the exception of Admin Settings, you cannot use any of the other ReM pages without first
finding at least one device on the Find page.
The Find page lets you search for scanners on your network. When you log into the ReM web interface,
the Find page is the first page displayed.
The Find page has multiple tabs so that you can keep the results of different search operations. These
tabs are also available on other pages so that you can use them for a variety of operations. You can use
the Find page to search for a device in the network using two different methods:
• IP Addresses displays all of the IP address ranges that are defined on the Admin Settings page (see
page 3-3). Searching by IP addresses allows you to select multiple subnet groups and specific IP
address ranges within each group. You can select an entire subnet group or limit your search to specific
IP address ranges within that group. IP Addresses is the default search method.
• Locations displays the information from the Location file specified on the Admin Settings page (see
page 3-4). This Find method allows you to search a range of subnet names within a single Location
(subnet group).
Performing a Find
1. Select the method of search: IP Addresses or Locations.
Note: Click on a Subnet Group to display all of the Subnet Names within it.
2. Click Check/Uncheck All to select all IP address ranges, or narrow your find operation by selecting
only IP addresses or Locations you wish to search.