User manual

2 - 22
3. Expand Ports (COM & LPT) and Universal Serial Bus controllers. If the USB serial device is
installed correctly, the scanner should display under both categories:
Note: Honeywell scanner models that begin with MS or IS (or legacy Metrologic devices) display as
“Honeywell Bidirectional Device”. For other Honeywell (and legacy Hand Held Products) devices,
the scanner model number displays.
4. Under Universal Serial Bus Controllers, right click on the device.
5. Select the Details tab and make a note of the four digits following “PID_”. In the example below, the
four digits are “0730”.
6. Click OK to return to the Device Manager.
7. Under Ports (COM & LPT) right click on the device and select Properties.
8. Select the Force COM port tab.
9. Check Force COM Port Feature enabled.