User manual

2 - 5

1. Double-click Setup.exe.

2. Select Client (Host Computer).

3. Select a Scanner Model.

Note: Logical Name, Interface and the ReM Scanner Licensing Tool only apply to Honeywell models

with an “IS” or “MS” prefix or legacy Metrologic scanners. For all other models, ReM automatically

assigns a Logical Name of “HHI” followed by the scanner model number.

4. If your scanner model number does not have an “IS” or “MS” prefix, skip to Step 11.

If your scanner model number begins with “IS” or “MS”, type in a Logical Name using a combination

of letters, numbers or underscores. (Do not use other special characters.) For example, the logical

name for an MS7580 connected by USB could be “MS7580USB”. Logical Name is used by the

JPOS driver to communicate with the device.

Note: If you try to enter a Logical Name beginning with “HHI” for an IS or MS scanner, ReM displays the

following message: “HHI prefix not allowed in logical name for selected scanner.”

5. Select an Interface.

If you select RS232, choose the port number to which the scanner is connected from the drop down

list.

If you select USB Serial (Virtual COM), the installer can automatically detect the port or you can

choose from the drop down list. If you choose Autodetect Port, the automatic port detection is

performed every time the computer reboots or when you restart the client agent (see page 3-28). If

you select a specific port from the list you must ensure the driver always assigns the same port by

using the Force COM option of the Honeywell USB Serial Driver (see page 2-21). For more

information about the Honeywell USB Serial Driver, visit the software download section of