User Guide

INSTALLATION Honeywell • 21

Protection class IP21: Cut free the opening on the AC drive cover for the Ether-net

cable.

Protection class IP54: Cut the rubber grommets open to slide the cables through.

Should the grommets fold in while inserting the cable, just draw the cable back a bit to

straighten the grommets up. Do not cut the grommet open-ings wider than what is nec-

essary for the cables you are using.

NOTE! To meet the requirements of the enclosure class IP54, the connection between

the grommet and the cable must be tight. Therefore, lead the first bit of the cable out of

the grommet straight before letting it bend. If this is not possible, the tightness of the

connection must be ensured with insulation tape or a cable tie.

Remount the AC drive cover.

NOTE! When planning the cable runs, remember to keep the distance between the

Ethernet cable and the motor cable at a minimum of 30 cm.

9068.emf

IP54

9265.emf

IP21

Ethernet

cable