User Guide
Table Of Contents
- 1. Safety
- 2. Receipt of delivery
- 3. Technical data
- 4. Installation
- 5. Commissioning
- 6. Fault tracing
- 7. SmartVFD Compact Application Interface
- 8. Control panel
- 9. General purpose application parameters
- 9.1 Quick setup parameters (Virtual menu, shows when par. 13.1 = 1)
- 9.2 Motor settings (Control panel: Menu PAR -> P1)
- 9.3 Start/stop setup (Control panel: Menu PAR -> P2)
- 9.4 Frequency references (Control panel: Menu PAR -> P3)
- 9.5 Ramps and brakes setup (Control panel: Menu PAR -> P4)
- 9.6 Digital inputs (Control panel: Menu PAR -> P5)
- 9.7 Analogue inputs (Control panel: Menu PAR -> P6)
- 9.8 Digital and analogue outputs (Control panel: Menu PAR - > P7)
- 9.9 Protections (Control panel: Menu PAR -> P9)
- 9.10 Autorestart parameters (Control panel: Menu PAR -> P10 )
- 9.11 PI control parameters (Control panel: Menu PAR -> P12 )
- 9.12 Easy usage menu (Control panel: Menu PAR -> P0 )
- 9.13 System parameters
- 10. Parameter descriptions
- 10.1 Motor settings (Control panel: Menu PAR -> P1)
- 10.2 Start/Stop setup (Control panel: Menu PAR -> P2)
- 10.3 Frequency references (Control panel: Menu PAR -> P3)
- 10.4 Ramps & brakes setup (Control panel: Menu PAR -> P4)
- 10.5 Digital inputs (Control panel: Menu PAR -> P5)
- 10.6 Analoque inputs (Control panel: Menu PAR -> P6)
- 10.7 Digital and analoque outputs (Control panel: Menu PAR -> P7)
- 10.8 Motor thermal protection (parameters 9.7 - 9.10)
- 10.9 Autorestart parameters (Control panel: Menu PAR -> P10)
- 10.10 PI control parameters (Control panel: Menu PAR -> P12)
- 10.11 Easy usage menu (Control panel: Menu PAR -> P9)
- 10.12 Fieldbus parameters (Control panel: Menu PAR -> S2 )
70 Parameter Descriptions Honeywell
10
Figure 10.10: Automatic restart
10.10 PI CONTROL PARAMETERS (CONTROL PANEL: MENU PAR -> P12)
12.2 PI CONTROLLER GAIN
This parameter defines the gain of the PI controller. If the value of the param-
eter is set to 100% a change of 10% in the error value causes the controller
output to change by 10%.
12.3 PI CONTROLLER I-TIME
This parameter defines the integration time of the PI controller. If this param-
eter is set to 1,00 second the controller output is changed by a value corre-
sponding to the output caused from the gain every second. (Gain*Error)/s.
12.7 FEEDBACK MINIMUM
12.8 FEEDBACK MAXIMUM
Fault trigger
Motor stop signal
Motor start signal
Sup ervision
Wait time
par.10 .1
Restart 1 Restart 2
Trial time
par.10.2
Fault active
RE SET /
Faul t reset
Autoreset function: (Trials = 2)
Wait ti me
par.1 0.1
Wait time
pa r.1 0.1