User Guide

Honeywell Parameters 55
9
9.12 EASY USAGE MENU (CONTROL PANEL: MENU PAR -> P0)
9.13 SYSTEM PARAMETERS
Code Parameter Min Max Unit Default ID Note
P13.1
Parameter
conceal
01 1 115
0 = All parameters visible
1 = Only quick setup
parameter group visible
P13.2 Drive setup 0 3 0 540
0 = Basic
1 = Pump drive
2 = Fan drive
3 = Conveyor drive (HP)
NOTE! Visible only duri-
ing Startup wizard
Table 9.12: Easy usage menu parameters
Code Parameter Min Max Default Note
Software information (MENU PAR -> S1)
S1.1 Software package
S1.2 Power SW version
S1.3 API SW version
S1.4 API Firmware interface
S1.5 Application ID
S1.6 Application revision
S1.7 System load
RS485 information (MENU PAR -> S2)
S2.1 Communication status
Format: xx.yyy
xx = 0 - 64 (Number of error
messages)
yyy = 0 - 999 (Number of
correct messages)
S2.2 Fieldbus protocol 0 1 0 0 = FB disabled 1= Modbus
S2.3 Slave address 1 255 1
S2.4 Baud rate 0 5 5
0=300, 1=600, 2=1200,
3=2400, 4=4800, 5=9600,
S2.5 Number of stop bits 0 1 1 0=1, 1=2
S2.6 Parity type 0 0 0 0= None (locked)
S2.7 Communication time-out 0 255 10
0= Not used, 1= 1 second,
2= 2 seconds, etc.
Table 9.13: System parameters