Use And Care Manual

UNIVERSAL PERMANENT REPLACEMENT
HEPA FILTER FIT CHART
Cleaning the LifeTime HEPA
™
Permanent Filter* :
The LifeTime HEPA
™
Filter is vacuum-able and should be cleaned regularly for optimum
performance.
To Clean the HEPA Filter:
• DO NOT USE WATER OR OTHER LIQUIDS TO CLEAN THE HEPA FILTER.
• Turn the air purifier OFF and unplug from the wall outlet.
• After removing the filter assembly from the air purifier,
separate and remove the carbon pre-filter from the HEPA filter
and place aside (or discard if pre-filter needs replacement).
• To vacuum-clean the filter, hold the filter and run a vacuum
cleaner with a nozzle or brush attachment along the filter to
pick-up the dirt and particles (Fig. 3). Repeat along the entire
surface of the HEPA filter.
• Do not penetrate the HEPA paper pleats with the vacuum
attachment since tearing or puncturing can occur.
Use the filter fit chart below to determine how many filters and gaskets you will need to
complete the filter assembly for your air purifier model. To select the number of Universal
Permanent Replacement HEPA filters needed, find the first four digits of your Honeywell
enviracaire
®
model number in the table below, then read across to determine the quantity of
filters required. For example, if you have an air purifier 17000, you would need to purchase 2
Universal Permanent Replacement HEPA Filters. For directions on how to put your filter
assembly together, refer to “Instructions For Use” on the first page of this document.
Fits Model
Series
50100
17000
17005
10500
10590
Number of
Filters
1
2
2
2
1
Number of
Gaskets
1
0
0
0
1
Replaces
HEPA Filter
20590
20500
20500
20500
20590
Fig. 3
*Permanent filter life based on ordinary use and care.
HRF-11_Sheet_R3.qxd 8/12/05 4:05 PM Page 2