User Guide Digital Video Recorder HRDE4X4

Rev 2.00 7 Document 900.0399
03/06
Figure 2-1 NTSC/PAL Operation Switch
Connecting Peripheral Equipment
Figure 2-2 shows the rear panel connections. Refer to Table 2-1 to connect your network
system components.
Figure 2-2 Rear Panel Connections
Table 2-1 describes the rear panel connections as shown in Figure 2-2 from left to right.
Table 2-1 Rear Panel Connections
Connector Description
RS-422/485 Remote camera control (see Controlling a PTZ Camera, page 21).
ETHERNET Network the DVR using 10/100 MB Ethernet connector. Network to a PC
for remote monitoring and searching (see Setting Network Parameters,
page 21).
AUDIO IN Connect to a pre-amplified line level audio source, such as a microphone.
Note It is the user’s responsibility to determine if the local laws and
regulations permit recording audio.
AUDIO OUT Connect to an amplifier.
CH3 CH4
RS-232
VIDEO OUT VGA DC 12V
P
A
L
V
G
A
12
ON
PAL: Set to ON position
VIDEO IN
CH1 CH2
CH3 CH4
AUDIO IN
CH1 CH2 CH3 CH4
AUDI O O UTALARMSENSOR
RS-422/485
ETHERNET
RS-232
VI DEO OUT VGA DC 12V
P
A
L
V
G
A
CAUTION
WARN IN G
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
TO REDUCETHE RI SK OF FIRE O R E LECTRI C
SHOCK DO NOT EXPOSETHIS APPLIANCETO
RAIN OR MOISTURE
TO REDUCETHE R ISK OF ELEC TRIC SHO CK
NO U SER SERVICEABL EPART S INSID E. RE FER
SERV ICINGTO QUALIFIED SERVICE PER SONNEL
TX+ TX- RX+ RX-
1G G G G OUT234
12
ON