Installation Instructions

1 2 4 5 6
PRESS
ONCE
HOLD
5 SEC
PRESS
ONCE
Bind the Radiator Controller to the
evohome Controller
1
Remove the adjustment dial
2
Open the battery clip and insert
the AA batteries supplied
3
Close the clip and replace the adjustment dial
4
Press the button once − it
should say UNBOUND
5
While UNBOUND is displayed press
and hold the
button again for 5
seconds – it should say BIND
6
Press the button once – it
should say BINDING
7
You should receive a SUCCESS message on the
evohome Controller (if not go back and re-bind)
8
The name of the allocated zone should
appear on the Radiator Controller display
when you press the button
9
Either press the green tick to add
another Radiator Controller to the same
zone, or press the red cross
if you don’t
need to add another radiator to the zone.
Synchronisation
can take up to
4 minutes until
the current room
setpoint temperature
is displayed on the
Radiator Controller.
If BINDING is
not successful,
it is terminated
automatically after
approx. 10 minutes.
– or –
To cancel BINDING,
select EXIT using
the adjustment dial
and confirm with the
button.
!
7Installation & User Guide