user manual

System Overview

(cont’d)

–

Fire Protection

The fire protection portion of your security system (if used) is always on and will

sound an alarm if a fire condition is detected. Refer to the FIRE ALARM SYSTEM

section for important information concerning fire protection, smoke detectors and

planning emergency exit routes from your premises.

Burglary Protection

The burglary protection portion of your system must be turned on or "armed" before

it will sense burglary alarm conditions and sound an alarm. Your system can be

armed in one of four modes: STAY, AWAY, INSTANT and MAXIMUM. Refer to the

ARMING THE SYSTEM sections for instructions in using these modes of operation.

Your system also provides a CHIME mode for alerting you to the opening and closing

of doors and windows while the system is disarmed.

Memory of Alarm

When an alarm or trouble condition occurs, the keypad displays the number(s) of the

zone(s) that caused the problem, and displays the type of alarm or trouble (ex. FIRE,

ALARM, CHECK). The display remains until it is cleared by entering the OFF

sequence (security code + OFF key) twice.

Pager Notification

If you have chosen to be notified of alarms or other system conditions by pager, the

following codes will be sent to your pager by the control:

1811=Trouble 1911=Alarm

1001=Open 1002=Close