user manual

Fire Alarm System

(cont’d)

–

Silencing Fire Alarms

1. Silence the alarm by pressing the OFF key (security code not needed to silence

fire alarms). To clear the display, enter your code and press the OFF key again

(Memory of Alarm).

2. If the Keypad does not indicate a READY condition after the second OFF

sequence, press the READY key to display the zone(s) that are faulted. Be sure

to check that smoke detectors are not responding to smoke or heat producing

objects in their vicinity. Should this be the case, eliminate the source of heat or

smoke.

3. If this does not remedy the problem, there may still be smoke in the detector.

Clear it by fanning the detector for about 30 seconds.

4. When the problem has been corrected, clear the display by entering your code

and pressing the OFF key.